Fusion Engine Features
F2 is essentially a Mini Fusion Engine. It offers the same adjustability and performance as the Fusion Engine in a cylinder sized package.
The dual solenoid design of the F2™ provides the same functionality as the legendary Fusion Engine™ but in a more compact, efficient and flexible design. Dual solenoids allow for the nozzle and the poppet valve to be adjusted independently of each other for unparalleled control over both the loading time and air volume used. Additionally, this makes it possible to change the firing sequence giving it the ability to operate in both true closed bolt as well as "AEG" mode.
The F2™ incorporates a new one-piece, lightweight poppet valve design yet still operates on the same principle as the Fusion Engine™ poppet. This valve is able to operate at lower pressures and uses less air volume to function which optimizes air efficiency.
The standard F2 poppet is equivilent to the Red Low-Flow poppet of the Fusion Engine.
The F2™ nozzle is spring biased forward which provides a consistent loading force regardless of operating pressure. It shares the same spring as the Fusion Engine™ with both light and heavy spring options available to adjust the loading force.
The robust design of the F2™ allows for an operating pressure range of 45psi to 145psi which enables it to achieve velocities from CQB to DMR while employing only one nozzle for the entire velocity adjustment range.
F2 is compatible with virtually every AEG gearbox, including those with offset nozzles by using either a centerline or offset front cylinder. The front cylinders are interchangable and a centerline F2 may be converted to an offset F2 by simply swapping the front cylinder and nozzle.
Velocity Range: 250fps - 500fps
Operating Presure: 45-145 PSI
Compatibility: ALL AEG
Both F1 and JACK are "open bolt" systems, meaning the nozzle is in the rearward position when the system is idle and the round is fired during the forward movement of the nozzle. F2 is a dual-solenoid system which allows for complete control over the shot cycle.
F2 systems are covered by a 1 year warranty against defects in material or manufacturing.
Over 20 standard F2 nozzles are available for installation into a wide range of replicas. These are numbered, rather than named, since a single nozzle is often compatible with multiple replicas. The "Original Model" listed in the table is the replica from which the nozzle measurements were taken and is for reference.
If your gun is not listed in our Compatiblity Database a recommended nozzle length may calculated by measuring your original gearbox and applying the following formulas:
Centerline Nozzles: TIP = F + B - (A/2) + .293
Offset Nozzles: TIP = F + B - (A/2) + .175
A more precise measurement (which accounts for the hopup and bucking in use) may be obtained by installing a nozzle into the system which is slightly too long for the replica and measuring the nozzle setback when placed into the hopup.
If you do not see a Standard Nozzle listed within +/- .010" of the calculated measurement please contact us with your gearbox measurements and we can cut a custom nozzle for you.
PolarStar Airsoft was formed in 2009 as a part of PolarStar Engineering & Machine with the goal of bringing our engineering experience and focus on quality to airsoft. Since then, PolarStar has made innovative airsoft products of the highest quality, designed and manufactured in the USA.
PolarStar products, including the patented Fusion Engine are designed by airsoft players, incorporating airsoft experience with the feedback of the commnity.
